Brother SC-2000 Service Manual page 97

Connect the harness to each connector on the main PCB assy, as shown in Fig.
3.94.
Power supply PCB
Xenon unit detection/
release sensor
Control panel PCB
Power supply PCB
Thermal head
Set the ground wire of the main PCB assy on the main chassis with the screw.
Secure harnesses A and B in hook C of the bottom cover, as shown in Fig.3.95.
Shield plate
Ground wire
Paper feed motor
Manual feed detection
Room temperature
Automatic feed
detection
position detection
Harness B
Screw
Hook C
Stamp size detection sensor
Ribbon detection
Xenon unit release detection
Printing position detection
Trigger detection
Fig. 3.94
Harness A
Fig. 3.95
III - 75
Main motor
Main capacitor charge PCB
Not in use
Cover open/close detection
Main PCB
Main PCB bottom plate