Reassembly Of The Rollers - Brother SC-2000 Service Manual

2.4

Reassembly of the Rollers

While pressing ends A of the label nip springs in the directions of the arrows, pass
each end of the nip roller through the hole from the inside of the main chassis.
Slide the label nip springs so that their ends A will contact parts B of the nip roller.
Note 1: Check that ends A of the label nip springs make contact with parts B of the
nip roller, then apply grease to parts B of the nip roller.
Set the retaining rings on both ends of the nip roller from the outside of the main
chassis. Then, set the paper guide on the sensor bracket, as shown in Fig. 3.59.
Sensor bracket
Nip roller
Paper guide
Label guide assy
Retaining ring
Label guide
Label nip spring
Label nip spring
End A
Label nip spring
Retaining ring
Part B
Nip roller
Main chassis
Fig. 3.59
III - 45