Reassembly Of The Capacitor Case - Brother SC-2000 Service Manual

2.16

Reassembly of the Capacitor Case

Set the ground wire of the capacitor case on the main chassis with the screw, pass
connector A of the capacitor case through the hole in the bottom cover, and
connect it to the connector of the power supply PCB assy.
Connect connector D coming out of the bottom cover to connector B of the
capacitor case.
Set the capacitor case on the bottom cover, and secure it with the four screws, as
shown in Fig. 3.91.
Screws
Screws
Connector B
Connector A
Capacitor case
Capacitor case rank number
Connector C
Ground wire
Main chassis
Connector D
Bottom cover
Fig. 3.91
III - 72