Reassembly Of The Bottom Cover And The Main Chassis - Brother SC-2000 Service Manual

2.14

Reassembly of the Bottom Cover and the Main Chassis

Insert the end of the size detection PCB harness into the hole in the bottom cover,
and set it into hooks A, B, C, and D, as shown in Fig. 3.84.
Set the thermistor to the bottom cover and secure it in place using tape. Then, pass
the connector through hole A.
Pass the paper feed motor harness through hole C in the bottom cover.
Pass the drawer connector harness through hole B in the bottom cover.
Bundle all other harnesses coming out of the main chassis, and pass them through
hole A in the bottom cover.
Secure the harness of the transparent sensor assy B and the switch for the xenon
cassette with the harness of the transparent sensor assy A and the switch for
opening/closing the cover using fastening band L100, as shown in Fig. 3.85.
Main chassis
Thermistor harness
Bottom cover
Note: Arrange the harnesses at the left of rib A.
C
D
Fig. 3.84
Paper feed motor harness
A
Rib A
B
Fig. 3.85
III - 67
Size detection PCB harness
A
B
C
Fastening band L100
Harness of switch for
xenon reset
Harness of transmission
sensor assy B
Drawer connector
harness