Reassembly Of The Thermal Head Unit - Brother SC-2000 Service Manual

2.12

Reassembly of the Thermal Head Unit

Fig. 3.81 shows the thermal head unit.
Caution: Take care not to touch the thermal head heat generating points.
Set the thermal head unit on the two embosses on the head holder, and secure it
with the two screws.
Pass the thermal head unit harness between the rotation shaft and the head holder
guide, and pass it through the hole in the main chassis and to the outside, as shown
in Fig. 3.82.
Secure the thermal head unit harness on the main chassis with fastening band
L100, that is also used to secure the sensor assy, as shown in Fig. 3.80.
Thermal head unit
Thermal head unit
Heat generating points
Fig. 3.81
Fig. 3.82
III - 65
Screws