Bosch VIDEOJET X20 Installation & Operating Manual page 79

VideoJet X20
5.28.14 SNMP
The VideoJet X20 supports the SNMP V2 (Simple Network Management Protocol) for
managing and monitoring network components, and can send SNMP messages (traps) to IP
addresses. The unit supports SNMP MIB II in the unified code. If you wish to send SNMP traps,
enter the IP addresses of one or two required target units here.
If you select On for the SNMP parameter and do not enter an SNMP host address, the
VideoJet X20 does not send them automatically, but only replies to SNMP requests. If you
enter one or two SNMP host addresses, SNMP traps are sent automatically. Select Off to
deactivate the SNMP function.
5.28.15 1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required
target units here.
5.28.16 SNMP traps
You can select which traps are to be sent.
1.
2.
3.
5.28.17 Authentication
If a RADIUS server is employed in the network for managing access rights, authentication must
be activated here to allow communication with the unit. The RADIUS server must also contain
the corresponding data.
To configure the unit, you must connect the VideoJet X20 directly to a computer using a
network cable. This is because communication via the network is not enabled until the
Identity and Password parameters have been set and successfully authenticated.
5.28.18 Identity
Enter the name that the RADIUS server is to use for identifying the VideoJet X20.
5.28.19 Password
Enter the password that is stored in the RADIUS server.
5.28.20 Automatic IP assignment
If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you
can activate acceptance of IP addresses automatically assigned to the VideoJet X20.
Certain applications (VIDOS, Bosch Video Management System, Archive Player, Configuration
Manager) use the IP address for the unique allocation of the unit. When using such
applications, the DHCP server must support the allocation of static IP addresses based on
MAC addresses and must be configured accordingly, so that the unit receives the same IP
address after each restart.
Bosch Security Systems
Click Select. A new window will open.
Click the checkboxes to select the required traps. All the checked traps will be sent.
Click OK to apply the selection.
Installation and Operating Manual
Configuration Using a Web Browser | en 79
V3.5 | 2007.12