Audio - Bosch VIDEOJET X20 Installation & Operating Manual

44 en | Configuration Using a Web Browser
5.14

Audio

You can set the gain of the audio signals to suit your specific requirements. The current video
image is shown in the small window next to the slide controls to help you check the selected
audio source and improve assignments. Your changes are effective immediately.
If you connect via Web browser you must activate the audio transmission on the Livepage
Configuration page (see Section 5.32 Livepage Configuration, page 85). For other connections,
the transmission depends on the audio settings of the respective system.
NOTICE!
i
The numbering of the audio inputs follows the labeling on the unit and the assignment to the
respective video inputs. The assignment cannot be changed for Web browser connections.
5.14.1 Line In
You can set the audio signal gain for the line inputs. Make sure that the display does not go
beyond the green zone during modulation.
5.14.2 Line Out
You can set the line output gain. Make sure that the display does not go beyond the green
zone during modulation.
5.14.3 Selection
Click one of the option boxes and then click Set to display the level of the respective audio
input for orientation and to set the gain.
V3.5 | 2007.12 Installation and Operating Manual
VideoJet X20
Bosch Security Systems