Brady BP-PR PLUS Series Operator's Manual page 16

Maintenance
Cleaning
Note: When cutting through the label material instead of the label gap, remains of
adhesive may accumulate on the blades. If operating in backfeed mode, such
remains of adhesive may be deposited on the drive roller as well.
Clean the drive roller (see Printer Operator's Manual) and the cutter blades often.
7. Grease the cylindrical area [7] of the circular blade [8] with an all-around high
8. If the screw [5] was loosened during cleaning, adjust the initial state of the
9. Re-mount the cover sheet [1] using the screws M4x6 [2] and cover sheet [3]
12 Edition 04/10
quality grease. For that hold a greased brush on the cylindrical area and turn
the axle [6] with a screwdriver for slotted head screws (slot width 7 mm).
During the turning the area is all-around greased.
cutter (see "6-3: Setting Initial State of the Cutter" on page 14) .
using the screws M4x10 [4].
7 8 6
A C O
UTO UTTER PERATOR
' M
S ANUAL