Brady BP-PR PLUS Series Operator's Manual page 18

Maintenance
Changing the Blades
8. Remove spring [6] and lineal blade [12].
9. Insert the axle of the (new) lineal blade withe the washer (B) in the bearing
10. Hang in the slack spring [6] to the pins of the mounting plate [9] and the lineal
11. Turn the lineal blade [11] backwards. The spring [6] gets tense.
12. Insert the Axle of the (new) circular blade [2] with the washer (A) in the bearing
13. Place the washer (C) on the axle of the lineal blade.
14. Hang in the slack spring [13] to the pins [12,14] of the lineal blade and the
15. Push the bearing plate [15] onto the blade axles [2, 11]. The spring [13] gets
16. Append the bearing plate [15] to the profile [7] using the screws [8].
17. Attend on an accurate position of the bearing plate [15] to the profile [7] of the
18. Tighten the set screw [4] at the gear wheel.
19. Lubricate the circular blade (see "6-1: Cleaning" on page 10) and adjust its
20. Re-mount the cover sheets (see "6-1: Cleaning" on page 10).
14 Edition 04/10
[10] of the mounting plate.
blade [11].
5 6
9 10
A
B
[5] of the mounting plate.
bearing plate.
tense.
cutter and tighten the screws [8].
initial state (see "6-3: Setting the Initial State of the Cutter" on page 14).
7 2
11 12
2
C
11
A
UTO
8
13 14 15
C O ' M
UTTER PERATOR S ANUAL