7-2-Explanation Of Signals - Brady BP-PR PLUS Series Operator's Manual

Peripheral Interface
Explanation of Signals
7-2 Explanation of Signals
Pin
Signal
1 XSTART
2 XFEH
3 -
4 -
5 XEDG
6 XDNB
7 XEDST
8 GND
9 RXSTART
10 RXFEH
18 Edition 04/10
Start signal
Triggers the start of the print when using the "Cut on
demand" operating mode,
This signal is checked if there is a connection between signal
STA and ground GND.
External error
An error has occurred in an externally-controlled device.
The label print is stopped and the display of the printer shows
the message "External error".
After the error is corrected, it is possible to press the pause
key and the print job will continue. The last label printed
before the error occurred will be repeated. Pressing the
cancel key will stop the print job and the printer will be reset.
No existing print job
There is no print job currently available.
Printer is not ready
An error has occurred on the printer.
The label print is stopped and the details and type of error
can be read from the printer display ('Ribbon out'; 'Paper
out'; 'No label')
Print of label has started
The printing of a label is indicated with a
20 ms pulse.
Ground ( 0 V )
Start signal (reverse line)
External error (reverse line)
Description
A
Activation/
Active
State
Switch on
+24 V
between Pin
1 and Pin 9
Switch on
+24 V
between Pin
2 and Pin
10
-
-
Contact
between
Pin 5 and
Pin 14 is
open
Contact
between
Pin 6 and
Pin 14 is
open
Contact
between
Pin 7 and
Pin 14 is
open
C O ' M
UTO UTTER PERATOR S ANUAL