Brady BP-PR PLUS Series Operator's Manual page 20

Maintenance
Setting Initial State of the Cutter
4. Check the position of the clock wheel [11].
5. Mount the cover.
16 Edition 04/10
• If the clock wheel is in the right position 1, the edge [10] of the clock wheel [11]
is located in the area of the marking [9].
• If clock wheel is in position 2 or 3 turn the circular blade to reach position 1:
9 10 11
- Loosen screw [12] about 5 mm.
- Turn the circular blade by one or two full turns, until the planar area [8] of
the blade axle becomes parallel to the base plate [7] again and the clock
wheel reaches the position 1
- Tighten screw [12].
9 10
12
A
UTO
9 10
C O ' M
UTTER PERATOR S ANUAL