Mounting; 2-1-Mounting The Cutter Tray; 2-2-Mounting The Cutter - Brady BP-PR PLUS Series Operator's Manual

Mounting

Mounting the Cutter
2 Mounting
2-1 Mounting the Cutter Tray
1. Loosen the screws [1].
2. Place the cutter tray [2] on the screws [1] in front of the tear-off plate or the
3. Tighten the screws [1].
4. Adjust the length of the cutter tray [2] may by moving the slide [3].
2-2 Mounting the Cutter
Note: Disconnect the printer from the electrical outlet before mounting or removing
the cutter.
1. Loosen the screw [2].
2. Remove the front cover [1].
4 Edition 04/10
dispense plate and slide it to the left until it stops.
1
2
3
1
2
A C O ' M
UTO UTTER PERATOR S ANUAL