5-2-Operation With External Control - Brady BP-PR PLUS Series Operator's Manual

Operation
Operation with External Control
5-2 Operation with External Control
The auto cutters with peripheral interface additionally allow the mode "Cut on
Demand".
In this operating mode it is necessary to connect a trigger switch or an external
control to the peripheral interface on the cutter.
Note: This operating mode requires that there is a connection between Pin 13
(STA) and Pin 12 (GND) at the peripheral interface (see chapter "Peripheral
Interface").
The printout of one label or a number of labels with the following cut will be
executed if:
10 Edition 04/10
• a print job is available.
• the previous cut has finished.
• the trigger switch, or the external control sends the START signal.
A C O ' M
UTO UTTER PERATOR S ANUAL