Loading Material; 5-1-Standard Operation - Brady BP-PR PLUS Series Operator's Manual

4 Loading Material

Note: To prevent jamming, we recommend that material is loaded so that it exits
from the top of the roll.
5 Operation
5-1 Standard Operation
The printer is ready for operation when all connections have been made and all
materials are loaded correctly.
Note: To operate the cutter with continuous material in the printer menu, select
Setup > Print parameters>Label sensor the setting Endless media. Otherwise
no synchronization cut is performed.
1. Switch on the printer. The cutter performs a cut.
2. Press the feed key. For synchronization the media will be moved forward and
3. Activate the cut mode in the software.
4. Send a print job.
A C O ' M
UTO UTTER PERATOR S
• Load transfer ribbon and endless material as described in the printer's
Operator's Manual.
Use the tear-off mode information for loading endless material for cut mode.
• Place the media strip between the printhead and the drive roller, so that the
front edge of the strip reaches through the cutter.
cut off.
Printers synchronization is not necessary when the printhead was not opened
between print jobs, even if the printer was powered off between print jobs.
For direct programming use the C-command (see the Programming Manual).
All labels in the job will be printed without stopping and be cut as chosen in the
software: after each label, after a specific quantity of labels, or at the end of a
print job.
ANUAL
Loading Material
Standard Operation
9 Edition 04/10