Interface Cable; Connecting The Interface Cable - 3Com 3C13886 - Router OC-3 ATM SML Flexible Interface Card Installation Manual

3Com Router Module Guide
Table 3-29 LEDs on the ROUTER 1-PORT ADSL OVER POTS MIM panel
LED
LINK
ACT

3.11.4 Interface Cable

The interface cables that the ROUTER 1-PORT ADSL OVER POTS MIM uses are
regular telephone cables.
Note:
The standard equipping package of the ROUTER 1-PORT ADSL OVER POTS MIM includes the regular
telephone cable(s). You can separately order an external splitter as needed.

3.11.5 Connecting the Interface Cable

In G. Lite mode, no splitter is needed. You can directly connect the router to the PSTN
using a telephone cable, and simply connect the phone-set in parallel with the router at
the cable distribution box.
Full rate mode requires a splitter. Follow these steps to connect the cables:
Step 1: Plug one end of a telephone cable into the ADSL port on the router, and the
other end into the internal ADSL port on the splitter.
Step 2: Connect the telephone to the phone port on the splitter with another telephone
cable.
Step 3: Connect the external ADSL port on the splitter to the PSTN with a third
telephone cable.
OFF means the loop is inactive; ON means the loop has been activated and has
entered the data mode; blinking means the loop is being activated.
OFF means no data is being transmitted or received on the interface and blinking
means data is being transmitted and/or received.
Chapter 3 Multifunctional Interface Modules
Description
3-49