Interface Cable; Router 1-Port 10/100/1000 Mim; Introduction; Interface Attributes - 3Com 3C13886 - Router OC-3 ATM SML Flexible Interface Card Installation Manual

3Com Router Module Guide
LP/AL
Note:
AIS = Alarm indication signal; LFA = loss of frame alignment; RAI = Remote alarm indication

3.17.4 Interface Cable

Router 1-Port CT3 MIM and Router 1-Port CE3 MIM use the same type of interface
cables and make connection in the same way (see Section 3.16.4 for details).

3.18 ROUTER 1-PORT 10/100/1000 MIM

3.18.1 Introduction

ROUTER 1-PORT 10/100/1000 MIM, the 1-port 10Base-T/100Base-TX/1000Base-T
Ethernet electrical interface card, is used for router-to-LAN communication.
The cards support:
100 meters (328.1 ft.) of transmission segment over the category-5 twisted-pair
cable.
Operation at 1000Mbps, 100Mbps, and 10Mbps, auto-sensing.
Half-duplex/full duplex, autonegotiation

3.18.2 Interface Attributes

The following table describes the interface attributes of the ROUTER 1-PORT
10/100/1000 MIM:
Table 3-42 Interface attributes of the ROUTER 1-PORT 10/100/1000 MIM
Attribute
Connector
Number of connectors
Interface type
Interface standard
Cable type
Operating mode
ON means the interface is in a loopback.
Blinking means an AIS, LFA, or RAI alarm signal is present.
OFF means no loopback or alarm is present.
ROUTER 1-PORT 10/100/1000
MIM
RJ-45
1
MDI/MDIX
802.3, 802.3u, and 802.3ab
Ethernet cable
10/100/1000 Mbps auto-sensing
Half-duplex/full duplex, autonegotiation
3-64
Chapter 3 Multifunctional Interface Modules