Interface Leds - 3Com 3C13886 - Router OC-3 ATM SML Flexible Interface Card Installation Manual

3Com Router Module Guide
Cable type
Operating mode
Services supported

3.8.3 Interface LEDs

The following figure illustrates a 2-port panel.
Figure 3-38 2-port panel
The following figure illustrates a 4-port module.
Figure 3-39 4-port panel
Description about the LEDs on E1/E1-F panels is given in the following table:
Table 3-20 Description about the LEDs on E1/E1-F panels
LED
LINK
E1 75-ohm non-balanced coaxial cable
E1 120-ohm balanced twisted pair cable
120-ohm 4E1 conversion cable (4E1/4E1-F modules)
75-ohm 4E1 conversion cable (4E1/4E1-F modules)
Coaxial connector, network interface connector and 75-ohm to 120-ohm
adapter (with BNC connector)
E1, CE1, ISDN PRI (only supported by Router 2 and 4-Port CE1/PRI MIM)
FE1 (only supported by )
1) Backup
2) Terminal access service
3) ISDN PRI (only supported by Router 2 and 4-Port CE1/PRI MIM)
ON means the carrier signal has been received.
OFF means no carrier signal has been received.
3-33
Chapter 3 Multifunctional Interface Modules
Description