Router 1-Port 10/100/1000 Fic; Introduction; Interface Attributes; Panel And Interface Leds - 3Com 3C13886 - Router OC-3 ATM SML Flexible Interface Card Installation Manual

3Com Router Module Guide
Step 2: Power on the router and check the behavior of the LINK LED on the card panel:
ON means an Rx link is present and OFF means the opposite. In the latter case, check
the line status.

4.2 ROUTER 1-PORT 10/100/1000 FIC

4.2.1 Introduction

ROUTER 1-PORT 10/100/1000 FIC, the 1-port 10Base-T/100Base-TX/1000Base-T
Ethernet electrical interface card, is used for router-to-LAN communication.
The cards support:
100 meters (328.1 ft.) of transmission segment over the category-5 twisted-pair
cable.
Operation at 1000Mbps, 100Mbps, and 10Mbps, auto-sensing.
Half-duplex/full duplex, autonegotiation

4.2.2 Interface Attributes

The following table describes the interface attributes of the ROUTER 1-PORT
10/100/1000 FIC:
Table 4-5 Interface attributes of the ROUTER 1-PORT 10/100/1000 FIC
Attribute
Connector
Number of connectors
Interface type
Interface standard
Cable type
Operating mode

4.2.3 Panel and Interface LEDs

The following figures show the 1-PORT 10/100/1000 FIC panel.
1-PORT 10/100/1000 FIC,
RJ-45
1
MDI/MDIX
802.3, 802.3u, and 802.3ab
Ethernet cable
10/100/1000 Mbps auto-sensing
Half-duplex/full duplex, autonegotiation
4-11
Chapter 4
2