Chapter 4 Flexible Interface Cards (Router 6000); Router 2-Port 10/100 Fic; Introduction; Interface Attributes - 3Com 3C13886 - Router OC-3 ATM SML Flexible Interface Card Installation Manual

3Com Router Module Guide

Chapter 4 Flexible Interface Cards (Router 6000)

4.1.1 Router 2-Port 10/100 FIC

4.1.2 Introduction

The Router 2-port 10Base-T/100Base-TX FE interface card (3C13861) provides two
10/100 Mbps RJ-45 Ethernet interface(s) for router-and-LAN communication.
The cards support:
100 meters (328.1 ft.) of transmission segment over the category-5 twisted-pair
cable.
Operation at 100 Mbps and 10 Mbps, autosensing.
Full duplex and half-duplex, with the former in common use.

4.1.3 Interface Attributes

The following table describes the interface attributes of the FIC-FE cards.
Table 4-1 FIC-2FE interface attributes
Attribute
Connector
Number of connectors
Cable
Operating mode
Supported frame format

4.1.4 Panel and Interface LEDs

The following figure illustrates an Router 2-Port 10/100 panel.
RJ-45
1
Straight-through Ethernet cable
Full duplex/half-duplex
10/100 Mbps auto-sensing
Ethernet_II
Ethernet_SNAP
4-5
Description
Router 2-Port 10/100
2
Chapter 4