ProSafe Dual Band Wireless-N Access Point WNDAP360
Table 1. Top Panel LEDs
Item
LED
Description
1
Power/Test Off
2
Active
3
LAN
2.4
4
GHz
WLAN
5
5
GHz
WLAN
Rear Panel
1
Figure 2.
On (green)
Amber, then blinking
green
Off
On or blinking (green) Ethernet traffic is detected.
Off
Amber
Green
Off
On or blinking (green) Wireless 802.11b/g/n (2.4 GHz) LAN is ready or
Off
On or blinking (green) Wireless 802.11n/a (5 GHz) LAN is ready or wireless
2
3
Introduction
12
Power is off.
Power is on.
A self-test is running or software is being loaded.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after 1 minute the
LED remains amber or continues to blink green, it
indicates a system fault.
No Ethernet traffic is detected or no link is detected.
10 Mbps or no link is detected.
10/100 Mbps link is detected.
1000 Mbps link is detected.
Wireless 802.11b/g/n (2.4 GHz) LAN is not ready or
no wireless activity is detected.
wireless activity is detected.
Wireless 802.11n/a (5 GHz) LAN is not ready or no
wireless activity is detected.
activity is detected.
5
6
7
4