Configure Advanced Qos Settings - NETGEAR WNDAP360 Reference

Table 24. Advanced Wireless Settings (Continued)
Field
Preamble Type
Note: This setting does not apply
to the 802.11a/na modes.
Antenna
Note: This setting does not apply
to the 802.11a/na modes.
802.11d
Note: This setting does not apply
to the 802.11a/na modes.
Client Isolation
Max. Wireless Clients
4. Click Apply to save your settings.

Configure Advanced QoS Settings

For most networks, the default Quality of Service (QoS) queue settings work well. For
information about how to configure basic QoS, see
Service on page 56.
You can specify the settings on multiple queues for increased throughput and better
performance of differentiated wireless traffic such as Voice-over-IP (VoIP), other types of
audio, video, and streaming media, as well as traditional IP data.
The advanced QoS options on the wireless access point are as follows:
• AP EDCA parameters. Specify the access point (AP) Enhanced Distributed Channel
Access (EDCA) settings for different types of data transmitted from the wireless access
point to wireless clients.
• Station EDCA parameters. Specify the station EDCA parameters for different types of
data transmitted from the wireless clients to the wireless access point. If WMM is
disabled, you cannot configure the Station EDCA parameters. (For information about how
to enable WMM, see
ProSafe Dual Band Wireless-N Access Point WNDAP360
Description
Select one of the following radio buttons to specify the preamble type:
• Long. A long transmit preamble might provide a more reliable
connection or a slightly longer range. A short transmit preamble
gives better performance.
• Auto. The Auto settings automatically handles both long and short
preambles. The default setting is Auto.
Select one of the following radio buttons to specify the antenna:
• Internal. Enables the internal antenna. This is the default setting.
• External. Enables an optional external antenna.
Select this check box to enable support for additional regulatory
domains that are not in the current standard; support includes the
addition of a country information element to beacons, probe requests,
and probe responses. This check box is selected by default.
From the drop-down list, select one of the following options:
• Enable. Communication between wireless clients that are associated
to different virtual access points (VAPs) is blocked.
• Disable. Communication between wireless clients that are
associated to different VAPs is allowed. This is the default setting.
Enter the maximum number of wireless clients that can simultaneously
connect to the wireless access point at one time. The default setting is
64 clients.
Configure Basic Wireless Quality of Service
Advanced Configuration
Configure Basic Wireless Quality of
86
on page 56.)