Configure Basic General System Settings And Time Settings - NETGEAR WNDAP360 Reference

Configure Basic General System Settings and Time Settings

Note: After you have successfully logged in to the wireless access point,
the basic General system settings screen displays.

To configure basic system settings:
1. Select Configuration > System > Basic > General. The basic General system settings
screen displays:
Figure 8.
2. Specify the fields as explained in the following table:
Table 2. Basic General System Settings
Field
Access Point Name
Country/Region
3. Click Apply to save your settings.
ProSafe Dual Band Wireless-N Access Point WNDAP360
Description
This unique name is the wireless access point NetBIOS name. The name is printed
on the rear label of the wireless access point. The default is netgearxxxxxx, where
xxxxxxx represents the last 6 digits of the wireless access point MAC address. You
can replace the default name with a unique name up to 15 characters long. The
access point name can be retrieved through SNMP.
From the Country/Region drop-down list, select the country where the wireless
access point is installed.
Note: It might not be legal to operate this wireless access point in a region other than
one of those identified in this field.
Installation and Basic Configuration
19