Factory Default Settings - NETGEAR WNDAP360 Reference

Table 29. Technical Specifications WNDAP360 (Continued)
Feature
Management and Other Specifications
Network management
Maximum clients
Status LEDs
Electrical and Physical Specifications
Power adapter
Physical specifications
Environmental
specifications
Compliance
Note: For more information about compliance, see
Electromagnetic
compliance

Factory Default Settings

You can use the Reset button located on the rear of the wireless access point to reset all
settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to push and hold the Reset button for
approximately 5 seconds (until the Test LED blinks rapidly). This returns the wireless access
point to the factory configuration settings that are shown in the following table.
Note: Pressing the Reset button for a shorter period of time simply causes
the wireless access point to reboot.
ProSafe Dual Band Wireless-N Access Point WNDAP360
Description
• Remote configuration and management through the web management interface,
through SNMP, or through Telnet or SSH with the command-line interface (CLI)
• SNMP management supports SNMP MIB I, MIB II, 802.11 MIB and proprietary
configuration MIB
Limited by the amount of wireless network traffic generated by each node; a
maximum of 64 clients is supported.
• Power/Test LED
• Link speed LED
• Ethernet LAN
• Wireless LAN (2.4 GHz and 5 GHz)
12 VDC, 1A; plug is localized to country of sale
• Dimensions (h x w x d): 253.75 x 253.75 x 54.76 mm (10.0 x 10.0 x 2.16 in)
• Weight: 0.886 kg (1.95 lb)
Operating temperature: 0 to 55° C (32 to 131° F)
Operating humidity: 10–9%, noncondensing
FCC Part 15 Class B and Class E, CE, and C-TICK
Supplemental Information
Appendix C, Notification of
112
Compliance.