NETGEAR WNDAP360 Reference page 92

ProSafe Dual Band Wireless-N Access Point WNDAP360
f. Specify the settings as explained in the following table:
Table 26. Point-to-Point Bridge Profile and Authentication Settings
Field
Profile Definition
Profile Name
Remote MAC Address Enter the MAC address of the remote wireless access point (the MAC address
Authentication Settings
Network
Authentication and
Data Encryption
Description
Enter a profile name that is easy to remember. The default name is
NETGEAR-WDS-1.
of AP2 on LAN Segment 1 in
From the Network Authentication drop-down list, select Open System,
WPA-PSK, or WPA2-PSK. Your selection determines the options that the Data
Encryption drop-down list provides, and whether or not the WPA Passphrase
(Network Key) field displays.
Open System Although you can use the bridge communication without any
authentication and encryption, NETGEAR recommends that
you use WEP if you do select an open system. From the Data
Encryption drop-down list, select one of the following:
• None. No authentication and encryption.
• 64-bit WEP. Standard WEP encryption, using 40/64-bit
encryption.
• 128-bit WEP. Standard WEP encryption, using 104/128-bit
encryption.
• 152-bit WEP. Proprietary WEP encryption mode, using
128+24 bits encryption. This mode functions only with other
wireless station that support this mode.
WPA-PSK TKIP (Temporal Key Integrity Protocol) is the standard
encryption method used with WPA-PSK and the only
selection possible from the Data Encryption drop-down list.
In the WPA Passphrase (Network Key) field, enter a
passphrase. The passphrase length needs to be between
8 and 63 characters (inclusive).
WPA2-PSK AES (Advanced Encryption Standard) is the standard
encryption method used with WPA2-PSK and the only
selection possible from the Data Encryption drop-down list.
In the WPA Passphrase (Network Key) field, enter a
passphrase. The passphrase length needs to be between
8 and 63 characters (inclusive).
Note: NETGEAR recommends WPA2-PSK authentication
with AES encryption if you want to use the 11n rates and
speed.
Advanced Configuration
92
Figure 53 on page 90).