Troubleshooting - Krups KM1000 Manual

TROUBLESHOOTING

PROBLEM
Coffee brews too slowly
(more than 10 minutes)
The lid does not close
properly
Problems with programming
the Auto-on or the clock.
The stop-drip does not work
ELECTRICAL OR ELECTRONIC PRODUCT AT THE END OF ITS USEFUL LIFE
ENVIRONMENT PROTECTION FIRST!
Your appliance contains valuable materials which can be recovered or
recycled.
Leave it at a local civic waste collection point.
- Descale the machine (see "Descaling" page 8)
- Clean the brew basket and drip stop valve of coffee residue.
Also clean the permanent filter if applicable.
- Check that there are no issues with the power supply.
- Use a different quality coffee paper.
- Check that any coffee bean is not clogging the tank bottom.
- The filter holder must be seated & locked into the basket.
- Use the handle to seat the filter holder, and then turn the handle to
the locked position.
- Turn the machine off and unplug it from the power source.
Wait 1 minute and reconnect.
This can allow the electronics to reinitialize to factory settings.
- Clean the valve under running water, manually activating
the stop-drip.
POSSIBLE SOLUTIONS
English
11