Table of Contents
Advertisement
Before You Begin
Install and connect your HostRAID controller and internal disk drives (see
●
Create a bootable array (see
●
Create a driver disk (see next section).
●
Creating a Driver Disk
Before you install your driver, you will need to create a driver disk. You will need a floppy disk
to complete this task. To create a driver disk:
Set your system BIOS so that your computer boots from the CD drive. (For instructions,
1
refer to your computer's documentation.)
Click Create Driver Disk, from the Main Menu.
2
Select one of the operating systems from the list:
3
Windows
●
Linux
●
Netware
●
Select the type of operating system you want to use.
4
Select the version of the operating system.
5
When prompted, insert a floppy disk, then click OK.
6
The system creates the driver disk.
Remove and label the driver disk.
7
Continue with the instructions for your operating system:
8
For Windows, see next section.
●
For Red Hat Linux, see
●
For SuSE Linux, see
●
For NetWare, see
●
Installing with Windows
You will need your Windows Installation CD to complete this task. To install the HostRAID
controller driver while installing Windows:
Insert your Windows CD, then restart the computer.
1
Follow the on-screen instructions to begin the Windows installation.
2
When prompted to install a third-party driver, press F6.
3
Note:
seconds. If you miss your chance to press F6, restart your computer.
Chapter 7: Installing the Driver and an Operating System
page
29).
page
35.
page
35.
page
36.
When F6 is active, a prompt appears at the bottom of the screen for only 5
34
●
page
24).
Advertisement
Table of Contents
