Installing The Windows Driver; Installing The Driver When You Install Windows - Adaptec RAID 2120S Installation And User Manual

4 Click Create Driver Disk, then select the appropriate operating
system.
5 If you selected Linux, you must also select the architecture:
– i386—For Intel 386 or 486 computers
– i586—For Pentium I or II computers
– i686—For Pentium III, IV, or AMD K-6 computers
– Athlon—AMD Athlon computers
6 Select the appropriate floppy drive letter, then choose the
appropriate format. You need a full format only if the disk has
never been formatted or may have bad sectors.
7 Insert a floppy disk, then click OK. The system creates the
driver disk.
8 Remove and label the driver disk.
Now that you have created your driver disk, identify the appropriate
driver installation procedure and proceed with the installation.

Installing the Windows Driver

This section contains the following procedures:

Installing the Driver When You Install Windows

Installing the Driver in an Existing Windows System
Installing the Driver When You Install Windows
To install the driver while also installing the Windows operating
system, follow these steps:
1 Install and configure the controller and hard drives, as
described in
2 Create the bootable array, as described on
3 Create the driver disk, as described on
remove the driver disk.
4 Insert the Windows setup CD and restart the computer to begin
the Windows installation.
page 2-3.
Installing the Driver
page 2-5.
page 3-2. When finished,
3-3