Table of Contents
Advertisement
5
A)
Remove the plastic cover from the phone.
Label the button sheet to show any
programmed lines or button features, then
place the button sheet on the phone so the
holes fit over the buttons. Carefully replace
the plastic cover.
B
Make sure the swivel display is set to the lowest
position.
Connecting and Testing Telephones
1
To connect a phone, plug the modular telephone
mounting cord into a modular wall jack or directly
into a 206 module extension jack. (If you are
connecting a standard phone and its mounting cord
is loose, use a Lucent Technologies D2R mounting
cord instead.)
To install two phones (or other devices) on a single
extension jack, see "Combination Extensions" earlier
in this guide.
2
Test the telephone for proper operation. To
A)
test the power and lights on a system phone:
while the phone is idle, press and hold the [
button for five seconds.
B)
Before releasing the [
All lights should light, the ringer should sound,
and (on system display phones only) a test
pattern should appear on the display. (If not,
call for support as instructed on the inside
front cover of this guide.)
Replace the handset; the phone is now in
C)
normal operating mode.
#
] button, lift the handset.
#
]
Installation Procedures
15
Advertisement
Table of Contents
