Table of Contents
Advertisement
7
Press the power cord firmly into the power
A)
jack on the top right side of the primary
carrier's backplane until it locks into place.
B)
Plug the other end of the power cord into a
properly grounded three-prong wall outlet not
controlled by a switch.
Repeat Steps 7A and 7B for the expansion
C)
carrier, plugging its cord into the same wall
outlet as the primary carrier's cord.
To power up the control unit, push in the main
D)
circuit breaker on the expansion carrier first,
then push in the main circuit breaker on the
primary carrier, or move the on/off switch to
the "on" position ("l").
8
Check all green lights on the fronts of the modules.
If all lights are lit, you can go to the next section;
otherwise:
A)
If a single light is out, power down the control
unit, reseat the module, then power up the
control unit.
If multiple lights are out, power down the
control unit, reseat the leftmost module that
has a light out, then power up the control unit.
B) If the lights are still out, call for support as
instructed on the inside front cover of this
guide.
Connecting Lines and Extensions
If extensions are not wired to any modular jacks, call a
qualified service technician.
1
A)
Test for dial tone at the network interface jacks
before connecting outside lines to the control
unit. For the test, connect a standard phone
to the first network interface jack.
B)
Lift the handset and listen for dial tone. (If there
is no dial tone, contact your local telephone
company before continuing.)
Repeat for each network interface jack.
C)
2
A)
Connect line cords to the line jacks on 206 and
400 modules, starting with the top line jack on
the leftmost 206 module.
B)
Route each cord through the hook on the front of
the module.
10
Installation Procedures
Lights
555-1343
555-1344
555-1345
555-1346
Network
Interface
Jacks
Advertisement
Table of Contents
