Table of Contents
Advertisement
Required Parts
You will have up to four types of system component packages; Figure 1 shows
the contents of each package in the area marked by a dashed line. Check your
packages to be sure you have the parts shown here (if not, call for support as
instructed on the inside front cover of this guide).
Primary Carrier
Cover
AC Power Cord
Expansion Carrier
Expansion
Cover
Processor Module
Long Screw
AC Power Cord
Figure 1. Required Parts
You will need to obtain four #12 screws of the appropriate type for the wall and
weight of each carrier (a carrier with four 206 modules and a processor module
weighs approximately 27.5 pounds or 12.3 kilograms.) You also need two
lengths of #12 AWG or #14 AWG solid copper wire (not to exceed 25 feet or 7.6
meters each) for grounding.
In addition, if you need modular telephone cords to connect the extension jacks
on the control unit to the modular connecting blocks for extensions in the
equipment room, short telephone cords or wall plates to wall mount
PARTNER-model phones, or a 355A/355AF adapter and D8W telephone cord to
connect a call reporting device, order them before installation. Refer to
"Product Ordering Information" in Appendix B of the PARTNER II
Communications System Programming and Use guide for ordering instructions.
4
Required Parts
Primary
Backplane
Processor
Module
Long Screw
Backplane
Expansion Cable
PARTNER-34D
Programming
Overlay
206E/206EC Module
7-foot
Telephone
206E/206EC
Line Cords
Module
PARTNER-18D
Programming
Overlay
400E/400EC Module
7-foot
Telephone
400E/400EC
Line Cords
Module
Advertisement
Table of Contents
