Table of Contents
Advertisement
Assembling System Phones
All PARTNER-model system phones are shipped with a
stand for either desk mounting or wall mounting the
phone.
Desk Mounting
1
A)
Gently place the phone upside down.
B)
Route the telephone cord through the hole in the
top center of the stand.
2
Insert the tabs on the narrow end of the stand into
the slots on the inside bottom edge of the phone.
3
While pressing in the tabs that protrude from the
A)
wide end of the stand, lower the stand to the
phone.
Release the tabs to lock the stand into one of the
B)
three positions provided by the openings in
the back of the phone.
The height of the stand is adjustable to three
C)
positions: low, medium, and high. The phone
height can be adjusted by moving the locking
tabs to a different position.
4
A)
Turn the phone over.
B)
Remove the plastic cover from the phone.
Label the button sheet to show any.
programmed lines or button features, then
place the button sheet on the phone so the
holes fit over the buttons. Carefully replace
the plastic cover.
Adjust the swivel display to the desired angle
C)
(low, medium, or high).
D)
To access the User Instruction Cards, pull out
the tray located under the front of the phone.
13
Installation Procedures
Advertisement
Table of Contents
