744
Users Manual
Simulating RTDs
Refer to Table 6 for information about RTD
(Resistance-Temperature Detector) types
supported by the calibrator.
Connect the calibrator to the instrument under test as
shown in Figure 21. The figure shows connections
for two, three, or four-wire transmitters. For three or
four-wire transmitters, use the 4-inch long stackable
jumper cables to connect the third and fourth wires at
the source V
RTD jacks.
56
Note
Proceed as follows to simulate an RTD (Resistance-
Temperature Detector):
1. If necessary, press
2. Press
until the select RTD type display is
showing.
3. Press the
or
keys followed by
select the desired RTD type.
4. Enter the temperature you want to simulate as
prompted by the display, then press
for SOURCE mode.
to
.