Using The Backlight; Personalizing The Calibrator - Fluke 744 User Manual

744
Users Manual

Using the Backlight

Press to toggle the display backlight on and off.
When the backlight is on, the
top of the display. You can minimize battery usage
by setting the calibrator to turn the display backlight
off automatically. When the backlight is on and Auto
Backlight Off is activated, the
the top of the display. To automatically turn off the
backlight after a set time, proceed as follows:
1. Press .
2. Press to highlight
.
Off
3. Press or the
4. Press to highlight
5. To accept the timeout period shown on the
display, press
Done
step 6.
6. To change the timeout period, press
highlight the timeout period following
.
Timeout
26
symbol shows at the
symbol shows at
following
Off Auto Backlight
softkey.
Choices
, then press
On
to exit, and do not go on to
to
Backlight
7. Press
8. Enter your choice of timeout period in minutes
(accepted range: 1 to 120 minutes).
9. Press the
10. Press the
mode.

Personalizing the Calibrator

You can load your name or some other alphanumeric
identifier into the calibrator to be displayed at power-
up and in saved results. Proceed as follows to load
an identifier:
1. Press
.
2. Press
Next Page
3. Press
as .
ID
or the softkey.
Choices
softkey.
Done
softkey or to exit Setup
Done
.
twice.
to move the cursor to the same line