Setting Up The Orientation; Adjusting The Lens - Barco iCon H250 Owner's Manual

How to change the common address ?
1. Proceed in the same way as for the projector address
6.6

Setting up the orientation

What must be done ?
Depending on the mechanical orientation of the projector, the projector's internal settings have to be adapted.
The projector is shipped (default) with a table/front orientation.
How to set the orientation ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Orientation
5. Press → to pull down the menu
6. Use ↓ or ↑ to select the desired orientation
Image 6-7
7. Press ENTER
The projection is adapted and a bullet shows the active configuration.
6.7

Adjusting the lens

What must be done ?
Depending on the projection distance and the lens used, the image may not be at the desired size, position and/or may be out of
focus.
The projector will always allow you to shift your image vertically as well as horizontally (when available) to position it on the screen.
In addition, motorized lenses will also allow you to Zoom and focus the image.
All these lens parameters can be adjusted using the RCU, the local keypad or in the Installation menu of the projector's OSD.
• Zoom (only for motorized lenses)
• Focus (only for motorized lenses)
• Vertical Shift
The lens can also be adjusted via the dedicated keys on the remote.
R5976992 ICON H250/400 13/12/2006
6. Setup
35