Automatic Startup - Barco iCon H250 Owner's Manual

F 2
F 1
M EN U
Image 6-19
The menu item is stored in the quick access key
Factory pre-programmed functions
-F1 :
-F2 :
-F3 :

6.10.3 Automatic startup

What can be done ?
The automatic startup allows to bypass the standby state i.e. start up without going in standby state after switching on the projector.
This means that the automatic startup allows immediate restart of the projector after a power failure (breakdown), i.e. without passing
through the standby state, by recovering the previous settings (previous source,...).
This function can be disabled if undesired or inadequate for safety reasons, etc.
C
AUTION
precautions
Make sure that the projector (or the operators!) will not be affected by altered environmental conditions when
restarting at power resume.
Unless it is required, it is advised to leave this setting OFF.
In case of a power breakdown, this may introduce unwanted conditions at power resume : projector starting
up with high lamp temperature conditions, bad PC status, ...
How to enable/disable the Automatic startup?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Automatic startup
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable/disable the automatic startup
R5976992 ICON H250/400 13/12/2006
F 3
B A C K
:
If the Automatic startup function is enabled one must be aware of the fact that it involves safety
6. Setup
41