Barco Coronis Fusion 6MP Getting Started Manual page 52

Driver and Software Installation
Click "Yes" to accept driver's License Agreement, and then "Next"
5.
to continue.
Note: In a mixed board configuration (MXRT1150/2150 and
MXRT5200/7300), two separate drivers will be installed. The
master Install program will make two passes through the driver
installation process (i.e. License Agreement, Verify Installation
Options, etc.).
During installation, there may be a fair amount of display
6.
flashing, and the install wizard window may appear on different
displays. This is an expected behavior.
When the installation of all components has completed, the
7.
automatic reboot window will be displayed. Allow the system to
reboot.
To verify that the driver was installed, go to the Windows Control
Panel, select System, select Device Manager, then select Display
Adapters. Verify that Barco MXRT graphics boards were properly
identified, as shown below:
Automated display configuration
Once the drivers, software and documentation have been installed
and your system has been rebooted, the Barco Monitor Plug and Play
Software should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the Barco Monitor
Plug and Play Software fails to detect your Barco displays or fails to
52