Raid Bios - DFI LanParty UT NF590 SLI-M2R/G User Manual

RAID BIOS

NVRAID BIOS
The NVRAID BIOS utility is used to configure and manage RAID on
Serial ATA drives connected to SATA 1 to SATA 6.
After you power up the system and all drives have been detected,
the NVRAID BIOS status message screen will appear. Press the
<F10> key to enter the utility. The utility allows you to build a RAID
system on Serial ATA drives.
Sil3132 SataRAID BIOS
The Sil3132 SataRAID BIOS utility, supported by the Silicon Image
Sil 3132 chip, is used to configure and manage RAID on Serial ATA
drives connected to SATA 7 and SATA 8.
After you power up the system and all hard disk drives have been
detected, the Sil3132 SataRAID BIOS status message screen will
appear. Press the <Ctrl-S> or <F4> key to enter the utility. The
utility allows you to build a RAID system on Serial ATA drives.
Important:
Before creating RAID, make sure you have installed the Serial
ATA drives and connected the data cables otherwise you won't
be able to enter the RAID BIOS utility.
Refer to chapter 6 for steps in configuring RAID.
3
BIOS Setup
123