Internal I/O Connectors; Floppy Disk Drive Connector - DFI LanParty LT P35 User Manual

2
Hardware Installation
I/O Connectors

Floppy Disk Drive Connector

The system board is equipped with a floppy disk drive connector
that supports a standard floppy disk drive. To prevent improper
floppy cable installation, the floppy disk header has a keying mecha-
nism. The 34-pin connector on the floppy cable can be placed into
the header only if pin 1 of the connector is aligned with pin 1 of the
header.
Connecting the Floppy Disk Drive Cable
Install one end of the floppy disk drive cable into the shrouded
floppy disk header (J23) on the system board and the other end-
most connector to the floppy drive. The colored edge of the daisy
chained ribbon cable should be aligned with pin 1 of J23.
BIOS Setting
Enable or disable this function in the Integrated Peripherals submenu
("Super IO Device" section) of the BIOS. Refer to chapter 3 for
more information.
66
3 3
3 4
1
2