Basic Operations; Turning The Power On; Adjusting The Audio Volume - Alinco DJ-C7T Instruction Manual

4. Basic Operations

4.1 Turning the Power ON

Caution
If the external power supply is over 6.5 volts, "dC-ovEr" is
displayed on the LCD with the red and green LEDs
alternately blinking. If this occurs, disconnect the external
power supply jack from the transceiver immediately.
Otherwise the transceiver will be damaged.
Note that no warnings are displayed on the LCD if the
external power supply exceeds 6.5 volts when the
transceiver is ON.
Application of a voltage of over 10 volts will damage this
transceiver.
Never use the AC adaptor cable of other manufacturers.
Hold the key down for a
second.
To turn the power OFF, hold the
key down until the display
disappears.

4.2 Adjusting the Audio Volume

• There are 31 volume levels. (00-30)
• Default is set to 10.
1. Press the dial once.
" " will be displayed on the LCD indicating the present
volume level.
2. Adjust the volume level by rotating the dial.
As the value increases, the sound becomes louder.
3. Press the dial again or the PTT key to complete the
setting and to return to the operating mode.
It also returns to the operating mode when no dial operations
are made for 5 seconds.
Caution
When you use an earphone, be sure to set the volume to a
proper level. Also, the Audio Volume Level in the Setting
mode should be set to LOW. For more information, please
refer to "Audio Volume Level" on P.24.
4
13