Booster Function; Timer Function; Temperature Detection - Baumatic B23 User Instructions

Residual Heat Indicator
"H"
After use an will light in the power level indicator of the zone that has been in use
The residual heat indicator will remain illuminated until the temperature drops below 60° C, the
residual heat indicator may not illuminate if during the cooking period the temperature did not reach
60° C or above.

Booster Function

This appliance has a booster function facility provided on the 210 mm heating zone (B23 – Front left
Zone) (B24 – Back Right Zone) and is brought into action by pressing the key marked "
To bring the booster function into operation first select the appropriate heating zone and using the "
key select power level 9, then press the "
When the Booster function is brought into operation the 145 mm cooking zone is in operation and is
more than 600W the power to that zone will be reduced to 600W and the corresponding heat indicator
starts to display alternatively between the reduced power level and the previously chosen power level.
Switching Off The Appliance
There are two ways in which the hob maybe switched off after use, firstly select the zone to be
switched off and then by using the
the hob automatically switched itself off, Alternatively for a quick switch off option simply press the
On / Off key and the hob will switch off.

Timer Function

This model has a timer function that can be allocated to any of the cooking zones, to operate this
function you should first select a cooking zone and required heat setting, Then by pressing the timer
key the time required can be set using the
minutes. The timer starts counting down as soon as the required time is set. The time
remaining is displayed on the timer display, the time maybe adjusted once set and will start
the countdown again from the new time setting. Once the timer reaches zero the selected cooking zone
will switch off and an audible signal is emitted and continues for 30 seconds.

Temperature Detection

For added safety, your induction hob incorporates independent detectors on each induction zone as well
as a sensor on the internal cooling block. These sensors will activate the fan as appropriate, if for any
reason the temperatures on any of the cooking zones were to exceed the safety levels, should this
happen then the zone will automatically reduce to a lower power level or in some cases switch off
altogether, If a zone is automatically switched off the "H" symbol will be displayed in the power level
indicator window.
Auto Pan-Detection
Each cooking zone incorporates an automatic pan-detection system, the system is calibrated in order to
recognize pans of a diameter just slightly smaller than the induction zone. Pans must always be placed
centrally on each cooking zone. If the zone does not detect the presence of a pan, the zone will stay off
and the power level indicator window will display the symbol "
pan is placed onto a cooking zone and is in the correct position, then this may mean that the pan is not
the correct size for that zone or is not appropriate for induction cooking.
+
" key and the display will change from 9 to P.
5 4
-
+ –
or keys decrease the zone heat setting to zero, after 10 seconds
+ –
or keys, the timer can be set from 1 to 99
+
U
". If this symbol is displayed when a
H
" .
-"
P
9