Alarm Timer Function; Protection From Overheating - Baumatic BMEH94I1G Instructions For Use And Installation

Timer

Alarm timer function

Protection from overheating

Induction hotplate is also fi tted with safety device against overheating which protects
electronic parts from damages. This device operates on several levels. When
temperature of the hotplate excessively rises, it switches on two-stage fan. If this is not
enough, extra powerful heating is deactivated, and finally the safety device either reduces
the heating power of certain hotplates or turns them off completely. When the hotplate
cools off, the full power of hotplate is again available.
Use of timer facilitates cooking by setting the time of hotplate operation.
Turning timer on
• Select the hotplate to be timer controlled, the respective decimal point (E1) lights and
timer display shows "CL".
• Turn the timer on by touching the sensor (F), at the beside of timer's display, the light of
the cooking zone of which timer is being set turns on.
• First the regulation of the second digital number has place and then the one of the first
digital number (the active number is displayed by the symbol "-" when the regulation
starts).
• By sliding along the entire slider, the exact tie can be set. By sliding to the right, the time
increases, while sliding to the left decreases the time setting by one minute steps.
• When you remove the finger, after a few seconds the timer starts the countdown.
Indicator displays actual power setting, and the dot beside of timer's display indicates
that timer is on.
Operation time can be set for each hotplate separately.
Changing preset cooking time
• Cooking time can be changed anytime during the operation.
• Select desired hotplate, (E1) lights, residual time is displayed on timer's display.
• Touch the sensor (F).
• By sliding along the entire slider area (B), the cooking time is changed by one minute
steps.
• When you move your finger away from the slider, the cooking filed starts operating with
the newly set cooking time.
• If time is not modified in 10 seconds since pressing the sensor (F), timer goes to zero
and then turns off automatically.
Checking remaining cooking time
• Last set timer is always displayed .
• Select cooking zone. The residual time of selected cooking zone will be displayed on
timer'
Turning timer off
When preset time elapses, a beep signals the end, and the hotplate is switched off.
Switch off the alarm by pressing the sensor of switch-off timer (F),or it switches off
automatically after 2 minuts.
If you want to switch the timer prior preset time:
• Select desired hotplate, (E1) lights. Cooking's residual
display.
• Touch the sensor (F).
• Pressing on the far left side of the slider deactivates the timer and the time set. The time
setting can also be reset by sliding along the entire slider area by 1 minute decrements.
• The illuminated point on the left part of the display is turned off and the timer is
deactivated.
Timer can be used as alarm only if it is not already employed in timer control of one of the
hotplates.
Timer setting
With the hob off:
• Touch the sensor (A) to activate the cooking hob.
• Touch the sensor (F) to activate the timer.
• Sliding a finger on slider area (B), set desired time.
• Values of zones' Cooking levels can be set:
▪ Before the first decimal number stops flashing (2 seconds).
▪ After setting alarm functions (cooking zones' displays turn off), it's enough pressing
sensor (A) again.
15
time is displayed on timer's