Installing A Device Into A Removable Media Bay - HP ML350T06 - E5520 Sff Us Svr Setup And Installation Manual

IMPORTANT: A hard drive blank must be installed into any empty drive bay for the system to
properly operate.

Installing a Device into a Removable Media Bay

The server includes four removable media bays. The lower two bays are occupied
with a 3.5-inch diskette drive and an IDE CD-ROM drive. The upper two removable
media device bays are vacant. You can install two half-height devices or one
full-height device into these bays.
Installing a Half-Height Removable Media Device
To install a 5.25-inch device:
CAUTION: To prevent damage to equipment or loss of information, be sure that the
server is powered down, all cables are disconnected from the server, and the power
cord is disconnected from the grounded (earthed) AC outlet before removing the
access panel.
1. Remove the access panel by following the steps in the section applicable to your
tower or rack server at the beginning of this chapter.
NOTE: For tower servers, the bezel door can be removed to simplify access.
2. To configure the device, set the SCSI ID. You must manually set the SCSI ID on
each device to a unique value. Refer to the documentation provided with the
device for instructions on setting the SCSI ID.
3. Remove all terminating jumpers from third-party SCSI devices.
4. Install guide screws on the sides of the drive.
HP ProLiant ML350 Generation 3 Server Setup and Installation Guide
Hardware Options Installation
3-15