Installing Component Rails On The Server - HP ML350T06 - E5520 Sff Us Svr Setup And Installation Manual

Overview of Server Installation

Installing Component Rails on the Server

Your conversion kit includes a set of adjustable-length slide rail assemblies. A slide
rail assembly consists of:
·
A component rail that is mounted to the server
·
A slide rail, which is the mechanism that accepts the component rail and is
mounted to the rail mounting bracket
The component rails are installed into the slide when shipped and must be removed
before the component rails can be mounted to the server.
To remove the component rail from the slide:
1. Extend the component rail from the slide until the component rail release latch
clicks (1).
2. Holding down the latch (2), pull the component rail out of the slide. You may
need to give the rail a sharp tug to disengage it from the slide.
Figure 2-4: Removing the component rail from the slide
2-14
2
HP ProLiant ML350 Generation 3 Server Setup and Installation Guide
1