Install Lock - Alarm Lock NARROW STILE ACCESS LOCKS Mounting And Installation Instructions Manual

Install Lock

4. Install the DL lock onto the door by aligning the four
tapped mounting holes in the back of the DL lock with
the four "through-bolting" holes that were drilled in the
door in step two.
Fig. 4: Install the DL lock onto the door
4a. Secure the DL lock to the door with four through-
door mounting screws and two door plates. Place a
door plate on top of a pair of mounting holes and
loosely secure lock from the inside of the door. Snug
all four mounting screws before final tightening. Do not
over-tighten.
Fig. 4a: Secure lock to door -- loosely at first
4b. Cover door plates with decorative plate covers by
sliding them from top to bottom on door plates.
Fig. 4b: Slide down to install decorative plate covers
4
Door plate
4c. Secure interface cylinder to lock by tightening the
set screw.
Fig. 4c: Secure interface cylinder to lock
Important! If the interface cylinder is not parallel to
the door after tightening the set screw, then you must
verify that the original Adams Rite
originally installed correctly (installed square to the
door). Failure to ensure the interface cylinder is in-
stalled correctly could cause lock binding or improper
operation of the lock mechanism.
4d. Install the deadbolt face plate.
Fig. 4d: Install the deadbolt face plate
®
lock body was