Install Batteries - Alarm Lock NARROW STILE ACCESS LOCKS Mounting And Installation Instructions Manual

Install Batteries

5. Insert key in cylinder and turn counterclockwise. This
will allow access to the battery compartment screw.
With the supplied 5/64" Allen wrench, loosen the bat-
tery cover screw only until the battery cover is able
to slide off. Remove the battery pack.
Note: Loosening the battery cover screw in excess of
what is necessary may interfere with the mechanical
operation of the key override assembly. Although the
lock will not be damaged, when the key is removed the
assembly may not function until the battery cover screw
is re-tightened.
Fig. 5: Loosen battery cover screw only until the battery
cover is able to slide off
5a. FOR NEW INSTALLATIONS: Refer to program-
ming instructions (OI310, OI311 or OI312) for spe-
cific instructions for "First Time Startup" and
"Change Factory Master Code" before connecting
the battery.
The lock must be powered up correctly (and have
its factory Master Code changed) or erratic lock be-
havior can result.
5b. Install battery pack into the battery compartment.
Neatly push all wiring inside the compartment. Hold-
ing battery in place, slide cover back on.
See Fig. 5b.
Fig. 5b: Install the battery pack
5c. While turning key counterclockwise again, allow-
ing access to the battery cover screw, tighten the
battery cover screw fully. Turn the key clockwise and
remove.
Fig. 5c: Turn key counterclockwise and
tighten the cover screw.
Test operation: See page 7.
5