Install Cylinder; Install Interface Cylinder - Alarm Lock NARROW STILE ACCESS LOCKS Mounting And Installation Instructions Manual

Install Cylinder

1. Install Cylinder if not already installed at the fac-
tory. Screws A & B (see Fig. 1) are correctly set at
factory. If it is difficult to screw in the cylinder, loosen
the two screws near the actuator (A) one turn. If you
find the cylinder is still difficult to screw in, then loosen
the other screws (B) one turn. Do not loosen the
screws all the way or it may be difficult to replace
them properly!
use a 1-1/8" or 1¼" Alarm Lock mortise cylinder with a
HW-1302 cam. If the cylinder that will be used is
longer than 1¼", a collar must be utilized. Please see
the collar information on the previous page.
A
Fig. 1: Install Cylinder if not already installed at the factory
1a. Insert key half-way into the cylinder, then screw it
in. See Fig. 1a. If cylinder will not seat flush, the cylin-
der back stop screw may require loosening. Cylinders
that are longer than 1¼"
will require a collar, which
will stick out from the sur-
face when correctly in-
stalled. Please see the
cylinder information on
the previous page.
1b. After the cylinder is screwed in all the way, center
the keyway toward the bottom (see Fig. 1b). If an
interchangeable core cylinder is utilized, then center
the interface toward the bottom. Tighten the screws
that were loosened in step 1.
Fig. 1b: Center keyway toward bottom
1c. Remove the key. Use a 1/16" hex wrench to screw
the cylinder back stop screw in fully. (See Fig. 1c)
The key should now only rotate counterclockwise.
Note: The trim is manufactured to
Cylinder back stop
screw
Fig. 1a: Insert key 1/2 way
into cylinder and screw in
NOTE: To remove cylinder, reverse steps 1a-1c.
Prepare the Door For "Through-Bolting"
2. Place template (WI1459)
B
as shown.
Place the template on top
of existing cylinder hole
and parallel to the door
edge.
2a. Drill completely through
the door for through-
bolting the four mount-
ing holes.
• IMPORTANT!--Drill
the holes STRAIGHT
THROUGH the door,
or the through-bolts
will not fit in the lock!
THIS IS ESSENTIAL!
Drill slowly and STRAIGHT through the door.
• Reposition the template as often as needed until
it is placed correctly.
Install the Interface Cylinder
3. Remove the existing cylinder (if present). Install
the new cylinder onto rear of lock. Ensure the tail-
piece at the rear of the lock enters the slot of the inter-
face cylinder. Tighten the set screw as shown in Fig.
3 below.
Fig. 3: Remove old interface cylinder (if present).
Fig. 1c: Use 1/16" hex wrench to screw in
the cylinder back stop screw
Important:
Fig. 2: Template (WI1459)
through-bolt holes (circled)
Screw
Install the new cylinder and tighten the screw.
Interface
cylinder
3