Advanced Mode: Alarm Connections - Bosch VJT-X20S Installation And Operating Manual

62 en | Configuration Using a Web Browser
5.27

Advanced Mode: Alarm Connections

You can select how the VideoJet X20 responds to an alarm. In the event of an alarm, the unit
can automatically connect to a pre-defined IP address. You can enter up to ten IP addresses to
which the VideoJet X20 will connect in sequence in the event of an alarm, until a connection is
made.
Connect on alarm
Select On so that the VideoJet X20 automatically connects to a predefined IP address in the
event of an alarm.
By setting Follows input 1 the unit maintains the connection that has been automatically
established for as long as an alarm exists on alarm input 1.
NOTICE!
i
In the default setting, Stream 2 is transmitted for alarm connections. Bear this fact in mind
when assigning the profile (see Section 5.19 Advanced Mode: Encoder Profile, page 48).
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote stations one after the other in the numbered sequence until a connection
is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Destination password
If the remote station is password protected, enter the password here.
In this page, you can save a maximum of ten destination IP addresses and hence up to ten
passwords for connecting to remote stations. If connections to more than ten remote stations
are to be possible, for example when initiating connections via higher-ranking systems such as
DOC | V4.0 | 2009.06 Installation and Operating Manual
VideoJet X20
Bosch Security Systems