Bosch VJT-X20S Installation And Operating Manual page 54

54 en | Configuration Using a Web Browser
CAUTION!
!
Activating or deactivating VRM causes the current settings to be lost; they can only be
restored through reconfiguration.
Recording media
Select the required recording media here so that you can then activate them and configure
the recording parameters.
iSCSI Media
If you want to use an iSCSI system as a recording medium, you must set up a connection to
the required iSCSI system and set the configuration parameters.
NOTICE!
i
The iSCSI storage system selected must be available on the network and completely set up.
Amongst other things, it must have an IP address and be divided into logical drives (LUN).
1.
2.
3.
Local Media
The supported local recording media are displayed in the Storage overview field.
Activating and Configuring Storage Media
The storage overview displays the available storage media. You can select individual media or
iSCSI drives and transfer these to the Managed storage media list. You can activate the
storage media in this list and configure them for storage.
CAUTION!
Each storage medium can only be associated with one user. If a storage medium is already
!
being used by another user, you can decouple the user and connect the drive with the
VideoJet X20. Before decoupling, make absolutely sure that the previous user no longer needs
the storage medium.
1.
2.
3.
4.
5.
DOC | V4.0 | 2009.06
Enter the IP address of the required iSCSI destination in the iSCSI IP address field.
If the iSCSI destination is password protected, enter this into the Password field.
Click the Read button. The connection to the IP address will be established. In the
Storage overview field, you can see the corresponding logical drives.
If the local recording medium is password protected, enter this into the Password field.
In the Recording media section, click the iSCSI Media and Local Media tabs to display
the applicable storage media in the overview.
In the Storage overview section, double-click the required storage medium, an iSCSI
LUN or one of the other available drives. The medium is then added to the Managed
storage media list. In the Status column, newly added media are indicated by the status
Not active.
Click the Set button to activate all media in the Managed storage media list. In the
Status column, these are indicated by the status Online.
Check the box in the Rec. 1 or Rec. 2 to specify which data stream should be recorded
on the storage media selected. Rec. 1 stores Stream 1, Rec. 2 stores Stream 2. This
means that you can record the standard data stream on a hard drive and record alarm
images on the mobile CF card, for example.
Check the boxes for the Overwrite older recordings option to specify which older
recordings can be overwritten once the available memory capacity has been used.
Recording 1 corresponds to Stream 1, Recording 2 corresponds to Stream 2.
Installation and Operating Manual
VideoJet X20
Bosch Security Systems