Table of Contents
Advertisement
Chapter 2
16
6. By default, if your network has a DHCP server, the storage system obtains its
IP address from that server.
If your network does not have a DHCP server, or if the storage system is directly
attached to your computer, the default IP address and subnet mask are used. (The
default IP address is 192.168.0.101, and the default subnet mask is
255.255.255.0).
To accept the default settings, click Next. Otherwise, specify the desired
settings and then click Next.
When you click Next, the Disk Configuration page displays. (The options that
appear on this page vary, depending on the number of hard disks that are
currently installed in the system.)
7. If you want to add or remove hard disks, do so one at a time and click Scan after
each action.
Note:
It is strongly recommended that you install all the hard disks that
you want to use in the storage system at this time, since changing the number of
hard disks later can require disk reconfiguration and possible data loss.
To accept the default disk configuration (which will provide the best level of data
protection available for the number of hard disks currently installed), click Next. By
default, a linear disk configuration is used for a single hard disk, RAID 1 is used for
two hard disks, and RAID 5 is used for three or four hard disks.
Getting Started
Altos easyStore Manual
16
Hide quick links:
Advertisement
Table of Contents
