Table of Contents
Advertisement
Chapter 5
142
The Restore dialog box displays.
13. Specify whether you are recovering to the original disk or a new disk.
If you are recovering to a new disk, select the desired disk from the list. Then
click Restore.
14. When the confirmation message displays, click Yes.
The backup is recovered to your local disk, and the progress bar displays the
progress of this process. You can cancel the recovery at any time by clicking
Stop on the progress dialog box.
Note:
Do not shut down your computer, disconnect from the
network, or perform any other tasks until this process is complete.
15. After the recovery is complete, click OK to restart your computer.
16. Use the appropriate procedure for your computer to configure it to boot from the
local disk once more.
17. If you changed the recovery password, reset it in the Microsoft iSCSI Initiator after
your computer restarts (as described in
in the Microsoft iSCSI
18. Start DiskSafe Express and remove protection from all your disks and partitions
(as described in
"Removing
boot and restarts your computer.) Then protect your disks again (as described in
"Protecting your
disks"), reusing the existing backups.
If you need to recover any other data disks or partitions, you can do so (as
described in
"Recovering a data
removed protection and then reprotected the disks.
19. Enable remote boot again (as described in
"Resetting the recovery password
Initiator").
protection"). (This disables remote
disk"). However, be sure to do this after you have
"Enabling remote
Protecting Local Disks
boot").
Altos easyStore Manual
Hide quick links:
Advertisement
Table of Contents
